Netgear: Using WNDR3700 as Wireless Access Point

Posted on November 16, 2011 by Masao 
Basic Configuration
  • WNDR3700 needs to be configured using its installation CD
  • After it is set to factory default, its default IP is 192.168.1.1
Access Point Setup
  • Plug your Internet connection into the WAN port (yellow) on the WNDR3700
  • Power cycle the router
  • The router will get a WAN IP and distribute IPs as necessary to connected clients

This entry was posted in Networking. Bookmark the permalink.

Leave a Reply

Your email address will not be published. Required fields are marked *

*

You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <strike> <strong>